TotalEnergies - Offa Town Service Station

Nice filling station. I will recommend over and over again

When to Put Water in an Inverter and How Much is Enough?

There is an indicator for inverter battery water filler level present on every battery. If the indicator is at the “Green” mark, you have adequate water in the inverter, and it is completely topped off. If it is at the “Red” mark, the water is below the advised level and a top-up is required.

Always make sure that the level is below the Green mark and above the Red mark. If it goes below Red, the acid is too concentrated, and the inverter can’t perform at its highest level. If the water level is above the Green level, the acid has diluted too much, and it can affect its working as well.

Steps Involved in Filling Distilled Water in the Inverter Battery:

With the above image’s help and the steps mentioned below, you will quickly learn to fill distilled water in your inverter battery.

Step 1: Check the level of distilled water in the battery with the aid of the water level indications. These water level indicators specify the amount of distilled water that is present in the inverter battery. While the lower level has a red mark, the upper level has a green mark.

Step 2: If the water level is low, as indicated by the red mark, it is time to fill water. But, before you start, make sure that you turn off the inverter and the power socket switch. You wouldn’t want any mishaps.

Step 3: Then, remove the water topping vent plugs by twisting it in an anti-clockwise direction.

Step 4: Once you have removed the vent plug, place a funnel in the hole (you can model a make-shift funnel using the top half of a pet bottle) and slowly pour the distilled water into the chamber.

Step 5: Continue this process for all the chambers. You can measure the level of water filled by placing the vent plus back in the hole and fill it up till it reaches the green mark.

Step 6: Once that is done, place the vent plug back and twist it in a clockwise direction to close the chamber. Repeat this process in the same manner for all the chambers.

Step 7: Finally, clean or wipe the battery, the vent plugs, and the water level indicators with a clean cloth.

Once you have finished filling distilled water in the battery, you can turn the power back on.



To help you further, below is a list of dos and don’ts you need to be wary of if you own an inverter battery.

Do’s:

Use only distilled water for your inverter battery.

Check the level of distilled water in your battery every month.

Wear gloves while filling distilled water in the battery.

Set a smartphone reminder at regular intervals that provide you notifications about the water levels.

Don’ts:

Avoid overfilling or underfilling distilled water in the inverter battery.

Allow the water to leak out of the chambers.

Use RO water or any other filtered water as a replacement for distilled water.

It's good to working with you

Not bad they try to serve you well

Good services, for oil and gas total energies provide the best service..they're reliable

Very good with few new service

At a nice location

Total is one of the filling station i respect most

Nice place

This is the fish pond

Quality service

Railway Station

Kunu